Automax offers the service to acquire vehicle datawith our own center of gravity • moment of inertia measurement system.
The data consists of four sets of "center of gravity height", "pitch and moment", "roll and moment" and "yaw and moment".
This data is acquired by Automax's center of gravity • moment of inertia measurement device, which provides high measurement accuracy, and is not affected by rolling resistance or axle friction.
Items of Sales
The following vehicle datas are provideded in a set.
- Center of gravity height Balance method: Inclination angle measurement
- PitchGravity pendulum method: Periodic measurement
- RollInverted spring pendulum: Periodic measurement
- YawSpring pendulum: Periodic measurement
Benefits of Automax measurement equipment
- Superior measurement accuracy – tolerance 0.5% (± 2.5 mm)
- Not affected by rolling resistance
- Not affected by axle friction
- Minimal drive friction
(If occurred, minimizes scattering)
Flow of measurements
- STEP01Vehicle loading
- STEP02Vehicle anchoring
- STEP03Data input
- STEP04Center of gravity measurement
- STEP05Pitch and moment measurement
- STEP06Roll and moment measurement
- STEP07Yaw moment measurement
- STEP08Measurement data output,
vehicle off loading
- Center
of gravity heightFront and rear 2×2
Average of 4 levels
- Pitch moment
of inertiaAverage of 3 times
- Roll moment
of inertiaAverage of 3 times
- Yaw moment
of inertiaAverage of 3 times
Contact Us
Phone number |
+81-3-3960-9001 Sales Department Office hours: 9:00 to 17:15 (Mon-Fri) |
Email |
request@automax.co.jp |